How To Change IP Address

21/06/2011 12:22

 

How To Change IP Address

 
Now it is very easy to change your IP Address.Here iam showing you how to cahnge your IP Address without using any software and in a very less amount of time but this method will only change your Dynamic IP address, not your ISP/IP address.

  •  Click on "Start" then go to "Run"
  •  Type in "command" and hit ok

There will appear a MSDOS CMD Prompt Screen

  • Type "ipconfig /release" and hit "enter"
  • Type "exit" and leave the prompt
  • Now go to "Network Places" Click on "properties"


You should now be on a screen with something titled "Local Area Connection", or something close to that, and, if you have a network hooked up, all of your other networks.

  • Right click on "Local Area Connection" and click "properties"
  • Double-click on the "Internet Protocol (TCP/IP)" from the list under the "General" tab
  • Click on "Use the following IP address" under the "General" tab
  • Create an IP address (It doesn't matter what it is. I just type 1 and 2 until i fill the area up).
  • Press "Tab" and it should automatically fill in the "Subnet Mask" section with default numbers.
  • Hit the "Ok" button here
  • Hit the "Ok" button again

You should now be back to the "Local Area Connection" screen.

  • Right-click back on "Local Area Connection" and go to properties again.
  • Go back to the "TCP/IP" settings
  • This time, select "Obtain an IP address automatically" Hit "Ok"
  •  Hit "Ok" again
  • You now have a new IP address